Panasonic PV-V4622 Terminal on the VCR with the RF Cable, Tvvcr VHF/UHF, OUT to TV

InitialSetupforDSS/CableBox➛VCR➛TVConnection

Please make all cable or antenna connections before plugging into the AC outlet.

Plugging the VCR Power Cord into an AC wall outlet starts auto channel and clock set.

How to Connect

1	Connect the OUT Jack on your cable box to the IN FROM ANT.
	terminal on the VCR with the RF Cable.
2	Connect the OUT TO TV terminal on the rear of VCR to the ANT.
	IN terminal on TV using the RF Cable (included accessory).

TVVCR

VHF/UHF 2

IN FROM ANT. Cable TV

	Converter Box
		IN from
OUT TO TV	1	ANT./CABLE

WARNING

When using “Nut type” RF coaxial cables, tighten with fingers only. Overtightening may damage terminals.

Doing Initial Setup (Ready to Play)

1 Turn TV on and tune to channel 3.

•Turn on your cable box and set it to

your Public Broadcasting Station (PBS) channel in your time zone. If you use a DSS receiver, it must be turned off.

2 Plug VCR Power Cord into AC wall outlet. VCR comes on and auto channel and clock set starts.

•If screen at right does not appear, check VCR - TV connection and, if TV is tuned to channel 3, try switching it to channel 4.

•To change VCR’s output channel, please refer to “VCR’s Output Channel” on page 13.

Plugging the AC Power Plug into an AC outlet

CH AUTO SET PROCEEDING

CANCEL : STOP

AUTO CLOCK SET

PROCEEDING

CANCEL : STOP

10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com