Panasonic SC-BT730, SC-BT330 Network Easy Setting, When you experience problems with settings

Network Easy Setting

Before you perform the wireless network settings on this unit, confirm the set up of your Wireless router (Access point) is done correctly on your PC.

1 Select “Wired” or “Wireless” and press [OK].

Network Easy Setting (Connection Check)

A settings check for home network and Internet connections is now being conducted.

Please select a connection mode first.

Current setting : Wired

LAN cable connection:

Connect a LAN cable to the unit and select “Wired.” Wireless LAN connection:

Insert a compatible Wireless LAN Adaptor to USB port and select “Wireless.”

Access point is necessary for Wireless LAN connection.

Wired

Wireless

OK

RETURN

2 Follow the on-screen instructions and make the settings with [3, 4] and press [OK].

For wireless LAN connection:

If you are using a Wireless router (Access point) that supports WPS, you can easily perform the settings by selecting “WPS (PUSH button method)”.

Otherwise, perform the settings by selecting “Search for access point” or “Manual setting” in “Other methods”.

Access Point Connection Setting

Select a connection method to use with an access point of Wireless LAN.

Please refer to the operating instructions of the access point about connection methods.

	WPS (PUSH button method)
	Other methods
OK	Search for access point
	WPS (PIN code method)
RETURN
	Manual setting

≥WPS (Wi-Fi Protected Setup) is a function that facilitates settings relating to the connection and security of wireless LAN devices. To see whether your Wireless router (Access point) supports WPS, check the Wireless router operating instructions.

VQT2M13

20

When you experience problems with settings

Access Point Connection Setting

Access Point Connection Setting

Failed to connect to the access point.

A conflict with another device occurred.

Do you want to configure Access Point Connection

Setting again ?

Yes	No
OK

	Display		Check the following
A conflict with another			≥ Please wait a few moments,
device occurred.			and then try again.
			≥ Setting of the Wireless
			router (Access point) for
A time out error occurred.			MAC Address etc.
			≥ The signal may be weak.
			Using the USB extension
			cable included with the
			Wireless LAN Adaptor,
			adjust the position of the
			Wireless LAN Adaptor.
An authentication error or a			≥ The SSID and the
time out error occurred.			encryption key of the
			Wireless router (Access
			point).
			≥ Please wait a few moments,
			and then try again.
			≥ Connection of Wireless LAN
A device error occurred.			Adaptor
			If there is no improvement in
			symptom, contact our
			Customer Service Center.
Network Easy Setting (Connection Check)
Network Easy Setting (Connection Check)
	Complete.
	1. LAN cable connection	: Fail
	2. IP address setting	: Fail
	3. Connection to gateway	: Fail
	LAN cable is not connected.
	Please check the connection.
	Select “Yes” and press [OK] to check network
	connection again. Select “No” and press [OK]
	to finish Network Easy Setting.
	Yes	No
	OK

	Display		Check the
			following
1.	LAN cable connection or	:Fail	≥ Connection of
Connection to access point			the LAN
2.	IP address setting	:Fail	cables (> 17)
3.	Connection to gateway	:Fail