Panasonic SC-BT330, SC-BT730 Listening to the Radio, Presetting stations automatically

Listening to the Radio

Presetting stations automatically

Up to 30 stations can be set.

1 Press [RADIO] to select “FM”.

2 Press [STATUS] to select the position to start the auto preset search.

LOWEST:

To begin auto preset with the lowest frequency (FM87.9 or FM87.5).

CURRENT:

To begin auto preset with the current frequency.*

*To change the frequency, refer to “Presetting stations manually”.

3 Press and hold [OK].

Release the button when “AUTO” is displayed.

The tuner starts to preset all the stations it can receive into the channels in ascending order.

≥“SET OK” is displayed when the stations are set, and the radio tunes to the last preset station.

≥“ERROR” is displayed when automatic presetting is unsuccessful. Preset the stations manually.

Presetting stations manually

Preparation

Select a radio broadcast.

1Press [RADIO] to select “FM”.

2Press [SEARCH6] or [SEARCH5] to select the

frequency.

≥To start automatic tuning, press and hold [SEARCH6], [SEARCH5] until the frequency starts scrolling. Tuning stops when a station is found.

1 While listening to the radio broadcast

Press [OK].

2 While “P” is flashing on the display

Press the numbered buttons to select a channel.

To select a 1-digit number e.g., 1: [1] B [OK].

To select a 2-digit number e.g., 12: [1] B [2]

≥A station previously stored is overwritten when another station is stored in the same channel preset.

Listening/confirming the preset channels

1	Press [RADIO] to select “FM”.
2	Press the numbered buttons to select the
	channel.
	To select a 1-digit number
	e.g., 1: [1] B [OK].		Playback
	To select a 2-digit number
	e.g., 12: [1] B [2].
	Alternatively, press [W, X] or [2, 1].
∫ Display on the main unit
TUNED/STEREO:		Displayed when receiving stereo
TUNED:		broadcasting
		Displayed when receiving monaural	Radio
		selected.
		broadcasting or monaural sound is

∫If noise is excessive

Press [AUDIO] to display “MONO”.

The sound becomes monaural.

Press the button again to cancel the mode. “AUTO ST” will be displayed on the main unit. Depending on the broadcast system, stereo or monaural will be selected.

“MONO” is also canceled when you change the frequency.

≥This setting can be preset for each broadcasting station.

∫FM frequency step

Main unit:

The factory setting is set to 0.2 MHz, it can be changed to receive broadcasts allocated in 0.1 MHz. You may need to change this setting if the tuner seems to skip over the correct frequency for stations in your area.

1Press [SELECTOR] to select “FM”.

2 Press and hold [SELECTOR].

After a few seconds the display changes to show the current lowest frequency. Continue to hold the button down. The lowest frequency changes and the step is changed.

To return to the original settings, repeat steps 1 and 2.

≥After changing the setting, previously preset frequencies will be cleared. Preset them again.

VQT2M13

29