Panasonic SC-HT65 manual Process for auto speaker setup, Auto speaker setup STEP

Auto speaker setup

•Turn off all components before making any connections.

•Peripheral equipment and cables sold separately unless otherwise indicated.

•To connect equipment, refer to the appropriate operating instructions.

Auto speaker setup allows you to achieve a satisfactory listening environment easily with the use of the supplied calibration microphone as a detector of sound signals. The unit will first perform automatic speaker detection, then checks and adjusts the following settings.

DETECTION	• Checks which speakers you have connected. For manual setup, “Speaker size”,
	➡ page 13.
DISTANCE	• Checks the distance of each speaker from the listening position and adjusts the
	timing of each channel. For manual setup, “Distance”, ➡ page 13.
SIZE	• Calibrates based on small speaker configuration.
	• Sets the appropriate low frequency crossover for each channel according to the
FREQUENCY	speaker size. For manual setup, “Filter”, ➡ page 12.
	• The setting is based on the speaker bass reproduction range.
	• Also checks on “Level” setting to adjust for each speaker.
LEVEL	• Makes any further corrections to the volume of each speaker and also to the
	frequency response.

Loud test tones are output from the speakers during setup, so keep children out of the room. Before setup

•Conduct the auto speaker setup in a quiet environment. A noisy background will give unsatisfactory results.

•Put the subwoofer in position, switch it on, and sets its volume to the level you would normally use.

Process for auto speaker setup

 Turn on the unit. Press .

•The standby indicator goes off when you turn on the unit.

Auto speaker setup STEP 4

Connect the calibration microphone to the [SETUP MIC] jack on the front panel.

Note

The calibration microphone is sensitive to heat. Keep it away from direct sunlight and do not place it on top of the unit.

Calibration microphone (included)

MENU TUNE

SETUP ENTER

RETURN

SETUP MIC

Placing of calibration microphone.

•Place on a flat surface at the seating area.

•Set calibration microphone position at your ear height.

•Use a tripod for best results.

RQTV0225

11

SC-HT65 GN-En.indb 11

8/17/2007 4:20:10 PM