\
∫BatteriesDo not:
≥mix old and new batteries.
≥use different types at the same time.
≥heat or expose to flame. ≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries. ≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can damage items the fluid contacts and may cause a fire.
Remove if the remote control is not going to be used for a long period of time. Store in a cool, dark place.
∫UseAim at the sensor (l 14), avoiding obstacles at a maximum range of 7 m (23 feet) directly in front of the unit.
After plugging the unit into your household AC outlet and pressing [Í] to turn the unit on for the first time, the unit automatically tunes in all the channels it can receive and sets the clock.
The unit determines the type of transmission, TV or CATV, as follows: TV: when there are less than 5 CATV channels.
CATV: when there are 5 or more CATV channels.
Preparation
≥Confirm that the antenna is connected correctly.
≥Turn on the television and select the video input for the VHS. ≥Press [VHS] to put the remote control in VHS mode.
Press [Í] to turn on the unit.The unit starts auto clock setting when finished, then displays the time.
[Note]
If auto tuning stops partway (by changing the source, turning the unit off, or due to a power failure).
1Disconnect the AC power supply cord on the main unit and then reconnect it.
2Turn on the main unit.
To cancel partway
Press [MENU].
∫To start
Preparation
≥Press [Í] to turn on the unit.
≥Make sure there is no video cassette tape loaded in the unit. ≥Press [DVD/VHS] to select “VHS” as the source.
1Press and hold [W CH] and [X CH] on the main unit simultaneously for 3 seconds until the channel changes to “2”.
2Disconnect the AC power supply cord on the main unit and then reconnect it.
3Turn on the main unit.
∫To set the channels manually (l 37).
∫If the unit couldn’t set the clock automatically
The MANUAL CLOCK SET screen appears. Set the time manually (l 36).
RQT7921
11