Simple Setup
Assembling the front and surround speakers
HT995&HT995W.bookPage 6Thursday,April27,20068:17PM | The supplied stands are specially designed for |
STEP1 Assembling the front and | speakers, |
surround speakers | attachment to Panasonic |
speakers. Use only as indicated in this setup. | |
|
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it. ≥For assembly, use
≥Make sure you have all the indicated components before starting assembly, setup, and connection. ≥There is no difference between the right and left speakers and stands.
≥For optional wall mount, refer to page 8.
[HT995]
[Note]
≥The front and surround speakers are different.
–Check the label on the rear of speaker before attaching the stand (➜ page 9).
–The stand with shorter cable is for the front speaker.
2 Front speakers and 4 Stands | 4 Bases | 12 Screws | 4 Sliders |
|
2 Surround speakers ≥2kstands with short cable: |
|
|
|
|
For front speakers |
|
|
|
|
≥2kstands with long cable: |
|
|
| The speaker height |
For surround speakers |
|
|
| |
|
|
| can be adjusted. | |
|
|
|
| |
|
|
|
| Min: 110 cm |
|
|
|
| Max: 135 cm |
1 Attach the speaker to the stand. |
| 2 Insert the stand into the base while gently pulling on the | ||
Place the polyfoam underneath the speaker for stability while | end of the cable. |
| ||
attaching the speaker to the stand. |
|
|
|
|
1 Feed the speaker cable (the shorter part) into the bottom |
|
| Cable | |
of the speaker and through the slot at the rear. |
|
| ||
|
|
| ||
2 While pulling the speaker cable up through the slot, slide |
|
|
| |
the speaker stand into the bottom of the speaker. |
|
|
| |
Cable |
| 3 Secure the stand to the base. | ||
Speaker |
| |||
Stand |
|
|
| |
|
|
|
| |
|
|
|
| Screw |
|
|
|
| Tighten securely. |
| Polyfoam | 4 Adjust the speaker height. |
| |
3 Thread the cable through the middle hole of the slider and | 1 Loosen the screws until |
| ||
the speaker can slide up |
| |||
fasten the slider with the two screws. |
|
| ||
| and down the stand. |
| ||
Cable |
| |||
| 2 Raise the speaker to the | |||
Slider |
| screwdriver | ||
| desired height, and then | |||
|
|
Screws | 5 Connect the speaker cable. | |
Insert the wire fully. | ||
Tighten securely. |
_: White
`: Blue
2 Attach the stand to the base. | Push! |
Press the speaker cable into the groove. |
1 Thread the speaker cable through the base.
| For quicker threading, loosely fold the cable in half (do not | Push excess cable back through the | |
| crease), pass the folded portion through the hole, and then pull | slider holder. | |
| the rest of the cable through the base. | 6 Secure the speaker cable to the base. | |
| Cable | ||
|
| Slide the cable | |
| Rounded side | into the groove. | |
RQT8766 | Cable | ||
| |||
Large hole |
| ||
|
|
Base
6