When placing the unit in a rack or on a table

Follow the safety measure to prevent the unit from falling.

The installation should never be done by any other than a qualified installation specialist.

Preparation

Commercially available components (not supplied)

 

≥Fall prevention cord............................................................................................................................

k 2

≥Screws to attach fall prevention cord to wall ......................................................................................

k 2

≥To prevent damage or scratches, lay down a soft cloth and perform the assembly on it.

 

 

 

≥Do not hold this unit in one hand to avoid injury by dropping this unit when carrying.

When the supplied leg stands are used

1 Attach a cord (not supplied) to the stand.

AStand (supplied) B Cord (not supplied)

C Thread a cord through the holes. Refer to the Operating Instructions of the cord for details.

2 Place the stand by aligning the holes in the stand with the projecting parts F.

≥Screw tightening torque: 80 N0cm to 120 N0cm.

≥Keep the screws out of reach of children to prevent swallowing.

 

D Screw with washer (supplied)

E Screw hole

F Projecting part

 

 

G Height adjustment holes

 

≥ By changing the position that

the stand is attached to the

projecting parts, the height can

be adjusted by 10 mm.

3 Place the unit in the desired position and attach each cord onto the rack or table.

≥Make sure that the slack is minimal.

≥Keep the screws out of reach of children to prevent swallowing.

H Screw eye (not supplied)

≥ Depending on the placement of the unit, the screwing position of the screw eye may differ.

14