When the supplied leg stands are not used
1 Attach a cord (not supplied) to 2 safety holders.≥Keep the safety holders out of reach of children to prevent swallowing.
≥Keep the remaining 2 safety holders for later use.
|
|
| A Safety holder (supplied) | |
| |
| B Cord (not supplied) | |
| | C Thread a cord through the | ||
| ||||
|
| holes. | ||
|
|
| ||
|
|
| Refer to the Operating | |
|
|
| Instructions of the cord for | |
|
|
| details. |
Precautions
2 Adjust the safety holder with the cord attached (> above), to fit the projecting parts and screw the safety holder firmly into place.
≥Screw tightening torque: 80 N0cm to 120 N0cm.
≥The safety holder is to minimize the possibility of damage and harm, but it does not guarantee this effect.
≥Keep the safety holders out of reach of children to prevent swallowing.
≥Keep the screws out of reach of children to prevent swallowing.
| | | ≥ The safety holder is placed |
|
| ||
|
| 突起部 | diagonally. |
|
|
| |
D Screw with washer (supplied) |
| F Projecting part | |
ESafety holder (supplied)
3 Place the unit in the desired position and attach each cord onto the rack or table.
≥Make sure that the slack is minimal.
≥Keep the screws out of reach of children to prevent swallowing.
G Screw eye (not supplied)
≥ Attach at a position capable of supporting over 33 kg.
≥ Depending on the placement of the unit, the screwing position of the screw eye may differ.
Getting started
15