38
VQT2L14
This unit will resume recording/pause mode
about 0.8 seconds after the LCD monitor is
reopened.
Start time will not shorten if there is no SD
card inserted.
/
Start time will be shorten if the
[Built-inMemory] is selected in the [MEDIA
SELECT], even if there is no SD card
inserted.
Start time will be shorten if the [HDD] is
selected in the [MEDIA SELECT], even if
there is no SD card inserted.
¬Change the mode to .
1Select the menu. (l27)
2Close the LCD monitor while

the mode is set to .

The status indicator A flashes green and the
unit goes into Quick start standby mode.
3Open the LCD monitor.
The status indicator A lights red and the unit
is put into recording pause.
When in Quick start standby mode
about 70% of the power used in
Recording pause mode is being
consumed, so the recording time will
be reduced.
Quick start standby mode is canceled if
jabout 5 minutes have elapsed
jmode is set to
It may take some time for Automatic white
balance to adjust.
In the Quick start mode, the zoom
magnification becomes 1k.
If [ECONOMY] (l29) is set to
[5 MINUTES] and the unit automatically
goes into Quick start standby mode, close
the LCD monitor and then open it again.
Turn the unit off using the power button.
When the power is turned on with the mode
set to , the unit will enter the recording
pause mode after about 1.9 seconds.
Select the menu. (l27)
In the Quick power on mode, the zoom
magnification becomes 1k.

Quick start

[SETUP] # [QUICK START] # [ON]
SDR-T55
SDR-T50
SDR-H85

Quick power on

[SETUP] # [QUICK POWER ON] #
[ON]
SDR-H85&S50&T55&T50-VQT2L14_eng.book 38 ページ 2009年12月22日 火曜日 午前10時33分