Panasonic SL-PR300 operating instructions Programming Playback Using Main Unit Controls

Listening to CDs

Programming Playback Using Main Unit Controls

It is possible to select your own program (order of tracks being played) using the program playback mode. Any of the tracks (1-99) on the CDs in the trays of the 3-CD changer can be selected.

If you want to program and record tracks, see “Program Edit Recording” on page 30.

	1					4,5
							MULTI JOG
	COMPACT DISC RECORDER SL-PR300					–	REC LEVEL
POWER	OPEN /	DISC					+
	CLOSE	SELECTOR			OPEN /
	DISC 3	3			CLOSE
	DISC 2	2
	DISC 1	DIGITAL	CD	LINE	REC SELECTOR
PHONES		1					MIX BALANCE

MIN	MAX							LINE	CD
		PLAY MODE	CD EDIT	CD REC	SYNCHRO	MENU	SET	CANCEL
					FINALIZE			REC/
								REC MUTE

2 7 3,4,5

1 Load CDs into the trays of the 3-CD changer.

•Only tracks on the CDs loaded in the 3-CD changer can be reg- istered into the program.

Note

•To close a tray, press the 0 button for the tray number that is open. If you press the 0 button for a tray number other than that for the tray that is open, the program may not be played correctly.

2 Press the PLAY MODE button when the unit is in the CD stop mode.

•The CD PLAYER indicator is shown in the display window, PROGRAM indicator is shown in the display window, and if no program has been registered, “PG NO PROGRAM” is shown in the information display.

Program step	Disc source
number

Track number

3 Press the SET button to start program registration.

•The information display will show the following, and disc source columns will flash.

Programming	Disc source
step number

Track number

4 Select the disc source (CD tray) by turning the MULTI JOG control, and then press the SET but- ton.

MULTI JOG
REC LEVEL	SET
–
	+
1. Select the disc.	2. Enter the selection.

CD1 CD2CD3

•When the SET button is pressed, next the programming step and track number columns will flash.

5 Select and enter a track number (1-99) by turning the MULTI JOG control, and then press the SET button.

MULTI JOG

REC LEVEL

SET

– +

1. Select the track. 2. Enter the selection.

•The following is an example of track 2 on the CD in tray DISC1 being entered as Step 01.

•When the SET button is pressed, the programming of Step 01 is registered, and programming for Step 02 is ready.

6 Repeat steps 4 and 5 to program up to a maximum of 32 steps.

•If you try to program over 32 steps, “MEMORY FULL” is shown in the information display, and the programming func- tion ends automatically.

•Pressing the CD Control STOP s button on the main unit ends the programming function.

RQT6087