TS
After use, be sure to take the Memory
Card out and detach the Battery from the
SD Video Camera or pull out the AC Cord
from AC Main socket.
If the Battery is used in an extremely
cold environment, the Battery may only
operate for approx. 5 minutes. If the
Battery becomes extremely hot, a
protective function may operate, and the
Battery may become unusable for a
while.
ªAbout the Lens
≥Do not touch the lens. Wipe the SD Video
Camera with a soft dry cloth when the lens
becomes unclean.
≥When condensation has taken place, set
the power switch to [OFF] and leave the
SD Video Camera in this condition for
about 1 hour. When the camera becomes
close to ambient temperature, the fog
disappears naturally.
≥Be careful not to touch the lens when
picking up the SD Video Camera from the
supplied Wearable Carry Case.
ªAbout the AC Adaptor
≥If the Battery is warm, charging takes
longer than usual.
≥If you use the AC Adaptor near a radio,
radio reception may be disturbed. Keep
the AC Adaptor 1 meter or more away
from a radio.
≥After use, be sure to pull out the AC Cord
from the AC Main socket.
≥Keep the electrodes of the AC Adaptor
and Battery clean at all times.
≥Remove the battery if the device is left
unused for a long time.
≥The temperature of the SD Video Camera
and the battery may rise while charging
the battery. Such rise of temperature does
not indicate a fault.
≥Do not install, remove, plug or unplug the
battery or power cord while the power is
on.
ªAbout the LCD Monitor
≥In a place with drastic temperature
changes, condensation may form on the
LCD Monitor. Wipe it with a soft dry cloth.
≥If your SD Video Camera is extremely cold
when you turn its power on, the image on
the LCD Monitor will be slightly darker
than usual at first. However, as the internal
temperature increases, it goes back to the
normal brightness.
ªOptimal Use of the Battery
Battery Characteristics
A lithium ion battery is a small-sized battery
with large capacity. However, when it is
cooled down due to the low temperature
(10 oC or less), the operating time becomes
short by its characteristics and it may not
operate properly. In this case, warm the
battery moderately (e.g. in a pocket) and
then insert it just before you use the
Camera. (When using a body warmer, be
careful not to directly make the battery
touched to it.)
Battery may be warm
The Battery may be warm after charge or
use. This is not a malfunction.
Extremely high precision technology is
employed to produce the LCD Monitor
screen featuring a total of approximately
123,000 pixels. The result is more than
99.99% effective pixels with a mere
0.01% of the pixels inactive or always lit.
However, this is not a malfunction and
does not affect the recorded picture.
AV100PP.book 76 ページ ２００３年８月２２日　金曜日　午後４時３０分