Installation

Connecting the Antenna Cable to the RF In Terminal

Antenna Connection - For proper reception of VHF/ UHF channels, an external antenna is required. For best reception an outdoor antenna is recommended. Antenna Mode must be set to TV.

VHF Antenna

UHF Antenna

Mixer

RF in Terminal

Coaxial

Antenna Plug

Clamper

75 Ohm Coaxial Cable

Using the Cable Cover

1.

Installing the cable clamp.

 

2.

Using the Cable Clamp

Coaxial

 

Open the cable clamp

 

 

 

cable

 

and pass the antenna

 

 

 

 

 

cable through.

Claw

 

3.Connect the antenna cable to RF in terminal.

4.Installing the Cable Cover

Insert the 2 upper claws into the mating slots.

Press in the bottom section of the cover.

Removing the Cable Cover

Release the 2 lower claws from their slots.

Slowly pull the cover downward.

Antenna / Cable Connection

Incoming Cable From Home Antenna (75 Ohm) / Incoming 75 Ohm Cable (From Cable Company)

VHF/UHF

Cable Connection - For reception of cable channels (01 - 125) connect the cable supplied by your local cable company. Antenna Mode must be set to CABLE. (Refer to Antenna Mode section.)

Note:

Certain cable systems offset some channels to reduce interference or have Premium (scrambled) channels. A cable converter box is required for proper reception. Check with your local Cable company for its compatibility requirements.

Antenna Connection (Cable Box, no VCR)

Use this configuration when connecting the TV to a cable TV system using a Cable Box.

ANTENNA

TERMINAL ON

THE LEFT SIDE

OF THE TV

Connect the cable from the Output terminal on the back of the Cable Box to the ANT terminal on the left side of the TV.

CABLE BOX

OUTPUT INPUT

TERMINAL ON THE BACK

OF THE CABLE BOX

Incoming Cable from Antenna or Cable TV System

8

Page 8
Image 8
Panasonic TC 15LV1 Connecting the Antenna Cable to the RF In Terminal, Antenna / Cable Connection, Using the Cable Cover