Safety Precautions
CAUTION
This LCD Display is for use only with the following optional accessories. Use with any other type of optional accessories may cause instability which could result in the possibility of injury.
| (All of the following accessories are manufactured by Panasonic Corporation.) |
• | |
• | |
• ATSC Tuner for Hospitality | Enseo DTB1510 / Enseo DTB1510 TB |
• Main Board (32") | TNM4CD0819FA |
• Main Board (37") | TNM4CD0819FB |
• Power Board (32") | TNM4CD0821F |
• Power Board (32"/37") | TNM4CD0822F |
• IR Board | TNM4CD0906F |
• RS232 Board | TNM4CD0820F |
•SW+AV3 Board (37") | TNM4CD0807F |
• Key Board (32") | TNM4CD0809F |
• AV3 Board (32") | TNM4CD0810F |
• SPEAKERS | TTX4CM008C |
Always be sure to ask a qualified technician to carry out
Small parts can present choking hazard if accidentally swallowed. Keep small parts away from young children. Discard unneeded small parts and other objects, including packaging materials and plastic bags/sheets to prevent them from being played with by young children, creating the potential risk of suffocation.
When using the LCD Display
Do not bring your hands, face or objects close to the ventilation holes of the Display.
•Top of the Display is usually very hot due to the high temperature of exhaust air being released through the ventilation holes. Burns or personal injuries can happen if any body parts are brought too close. Placing any object near the top of the display could also result in heat damages to the object as well as to the Display if its ventilation holes are blocked.
Be sure to disconnect all cables before moving the
Display.
•Moving the Display with its cables attached might damage the cables which, in turn, can cause fire or electric shock.
Disconnect the power plug from the wall outlet as a
safety precaution before carrying out any cleaning.
• Electric shocks can result if this is not done.
Clean the power cable regularly to prevent it from becoming dusty.
•
This Display radiates infrared rays, therefore it may affect other infrared communication equipment. Install your infrared sensor in a place away from direct or reflected light from your Display.
Note:
Image retention may occur. If you display a still picture for an extended period, the image might remain on the screen. However, it will disappear after a while.
To Prevent the Display From Falling
Required accessories: | A Holding Strip (1) | B Assembly screw (1) | C Wood screw (1) |
size: 4 mm x 10
1.Use the wood screw to attach the holding strip to the base table (C).
Note:
If the base table has no hole, align with the hole on the holding strip and dig one on the base table.
2. Screw the holding strip to the pedestal (B).
Note:
Make sure that the holes on the holding strip are properly aligned with the pedestal and the base table to ensure stability and prevent the Display from falling down.
B
C
A
