Viewing 3D images
Disposal
(for the supplied 3D Eyewear:
A
When disposing this product, disassemble properly by following the procedure below, and remove the internal rechargeable battery.
Do not disassemble this product except when disposing of it.
■ Danger
•As the rechargeable battery is specifically for this product, do not use it for any other device.
• Do not charge the removed battery.
• Do not throw the battery in a fire, or apply heat to it.
• Do not pierce the battery with a nail, subject it to an impact, or dismantle or modify it.
• Do not let the wires touch any other metal or each other.
• Do not carry or store the battery with a necklace, hair pin, or the like.
• Do not charge, use, or leave the battery in a hot location such as near a fire or under the hot sun. Doing so may cause the battery to generate heat, ignite, or rupture.
■ Warning
•Do not place the removed battery, screws, and other items within reach of infants. Accidental swallowing of such an item may have an adverse effect on the body.
• In the event that you think such an item has been swallowed, consult a doctor immediately.
•In the event of fluid leaking from the battery, take the following measure, and do not touch the fluid with bare hands.
Fluid entering into an eye may cause loss of eyesight.
• Wash the eye with water immediately without rubbing it, and then consult a doctor. Fluid getting on your body or clothes may cause inflammation of the skin or injury.
•Sufficiently rinse with clean water, and then consult a doctor.
■How to remove the battery
Disassemble this product after the battery has run out of power.
The following figures are intended to explain how to dispose of the product, not for describing how to repair.
The product cannot be repaired once it has been disassembled.
1 Fold the part of the |
|
| 2 Bend the frame | Side cover |
frame without the |
| Screws | inwards and pull |
|
power switch, and |
|
| ||
| it off from the side |
| ||
then remove the |
|
|
| |
|
| cover. |
| |
two screws on the |
|
|
| |
|
| • If it is difficult to |
| |
inside of the hinge |
|
| remove, insert a |
|
with a precision | Frame |
|
|
|
Phillips (plus + ) |
|
| screwdriver and | Battery |
screwdriver. |
|
| force it off. | |
|
|
| ||
3 Remove the battery |
|
| Note |
|
from inside the side |
|
|
| |
|
| •Take sufficient care when performing this work so | ||
cover, and cut the |
|
| ||
two wires one by |
|
| as not to injure yourself. |
|
|
| •Do not damage or dismantle the battery. | ||
one with scissors. |
|
| ||
• Insulate the wire parts of the removed battery with cellophane tape.
32
