Panasonic TQBC2033 manual Connections, AC cord fixing, Close, Open

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.

Refer to the speaker’s Installation Manual for details on speaker installation.

	Speakers (Optional accessories)			1
				2	1
			SPEAKERS
			Terminals (L)		2
SPEAKERS		AC cord connection (see page 12)
Terminals (R)
		– AC cord fixing
		1	Connect the AC cord plug to	Close

			the Plasma Display.
3	1	2	Fix the left side clamper.	Push until the hook clicks.
		3	Fix the right side clamper.
2
				Open
				2. Pull off.
Note: The power plug in the illustration may not be the type fitted to				1. Keep the knob pressed.
your set.

–Cable fixing bands

Secure any excess cables with bands as required.

Pass the attached cable fixing band through the clip as shown in the figure.

1

To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.

While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.

To tighten:	To loosen:
	Push the catch
Pull
2	Pull

R AUDIO L	VIDEO IN	VIDEO OUT
IN	S VIDEO IN	AV
SLOT1	SLOT2

RAUDIO L PR/CR/R PB/CB/B Y/G

COMPONENT/RGB IN

SLOT3

AUDIO

PC IN

SERIAL

Optional Terminal	AV Terminals	COMPONENT/RGB IN	From EXTERNAL
Board Insert Slot	(see page 12)	and Audio IN Terminals	monitor terminal on
(covered)		(see page 12)	Computer (see page 10)

Note:

At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.

From SERIAL Terminal on Computer (see page 11)

9