Panasonic WJ-FS309, WJ-FS316, WJ-FS409, WJ-FS416 Alarm Setup Menu

11

1. Move the cursor on GROUP in the DYNAMIC REC

line and press the SET button to open the GROUP

SETUP menu shown above.

2. Move the cursor to the desired position by pressing

the C, D, A, Bbuttons.

Note: To turn over the page for WJ-FS316/FS416,

keep the cursor moving up or down.

3. Select the camera number by pressing the

Increment (+) or Decrement (–) button.

4. Repeat steps 2 and 3 until all groupings are

entered.

Note: Assigning one camera channel to plural

alarm inputs is acceptable.

2. ALM REC MODE

This item lets you select the time interval (field rate) for

switching the camera channel for the REC OUT signal. This

setting takes effect only when an alarm is activated.

1. Move the cursor to the ALM REC MODE parameter.

2. Select a field rate or EXT by pressing the +or –button.

The initial factory setting is 004.

004 - 128: REC OUT signal is switched from one cam-

era channel to another at the field rate specified

here. The appropriate field rate may vary depend-

ing on the VCR model. Consult the VCR specifica-

tions on the field rate.

EXT: Switching of the REC OUT signal is controlled by

the camera switching signal supplied by the con-

nected VCR.

1. DYNAMIC REC

This item lets you select the camera channel(s) whose pic-

ture is to be recorded on the VCR when an alarm signal is

received. There are priority options for recording of chan-

nel(s) ranging from equal priority of all channels to exclu-

sive recording of a specified channel.

1. Move the cursor to the DYNAMIC REC parameter.

2. Select OFF, ALM - PRI, ALM-ONLY or GROUP by

pressing the +or –button.

The initial factory setting is OFF.

OFF: The video signals are recorded from channels

number 1 to 9 (WJ-FS309/FS409) or 1 to 16 (WJ-FS

316/FS416) regardless of any channels receiving

the alarm signal.

ALM - PRI: The video signal of the channel that

received the alarm signal is recorded with more

fields than normal.

ALM-ONLY: The recording output is monopolized by

the picture of the channel that received the alarm,

while the pictures on other channels are omitted.

Note: ALM-ONLY is not applicable, when a WJ-DR200

AV Disc Recorder is connected to the unit.

GROUP: Up to 4 channels are merged into a group.

When an alarm is received, the video signals of this

channel group are recorded with more fields than

normal.

If the DYNAMIC REC parameter is on GROUP, proceed

as follows:

■Alarm Setup Menu

Move the cursor to ALARM SETUP on the SETUP menu,

then press the SET button. The ALARM SETUP menu

appears on the monitor screen as shown below.

WJ-FS316 SETUP

ALARM SETUP

MONITOR OUTPUT SETUP

REC OUTPUT SETUP

SEQUENCE SETUP

SYSTEM SETUP

ALARM SETUP

DYNAMIC REC OFF

ALM REC MODE 004

AUTO RESET OFF

ALM DISPLAY ON

ALM OUTPUT 2S

ALM BUZZER 2S

ALM INPUT N.O.

VIDEO LOSS ON

MLT OUT MODE SPOT

SPT OUT MODE SPOT

2/2

GROUP SETUP 1/2

CH CH CH CH

ALM 1 → 1 -- -- --

ALM 2 → 2 -- -- --

ALM 3 → 3 -- -- --

ALM 4 → 4 -- -- --

ALM 5 → 5 -- -- --

ALM 6 → 6 -- -- --

ALM 7 → 7 -- -- --

ALM 8 → 8 -- -- --

GROUP SETUP