Panasonic WJ-FS416, WJ-FS409, WJ-FS316, WJ-FS309 manual Sequence Setup Menu, REC Mode, Auto Skip

2. REC MODE

This item lets you select the time interval (field rate) for switching the camera channel of the REC OUT signal. When REC MODE is set to EXT, the timing is controlled by the connected VCR. When 004-255 (INT) is selected, the timing corresponds to the field rate set here.

The parameter settings for different VCR models are shown in the ADDENDUM.

1.Move the cursor to the REC MODE parameter.

2.Select a field rate or EXT by pressing the + or – button. The initial factory setting is 004 (INT).

004 - 255 (INT): REC OUT signal is switched from one camera channel to another at the field rate speci- fied here.

Note: The appropriate field rate may vary depending on the VCR model. Consult the VCR specifications on the field rate.

EXT: Switching of the REC OUT signal is controlled by the camera switching signal supplied by the con- nected VCR.

Note: If set to EXT, make sure that the CAMERA SW IN terminal on the rear panel is connected to the Time Lapse VCR.

■Sequence Setup Menu

1. MULTI OUTPUT

WJ-FS316 SETUP

ALARM SETUP

MONITOR OUTPUT SETUP

REC OUTPUT SETUP

SEQUENCE SETUP

SYSTEM SETUP

Move the cursor to SEQUENCE SETUP on the SETUP menu, then press the SET button. The SEQUENCE SETUP menu appears on the monitor screen as shown below.

SEQUENCE SETUP
MULTI	OUTPUT
AUTO	SKIP	ON
SEQ MODE		QUAD
SPOT OUTPUT
AUTO	SKIP	ON

MLT/SPT SEQ SETUP

1-1. AUTO SKIP

This item lets you enable or disable the Auto Skip function to skip any steps where no video signal is present at the multiscreen output.

1.Move the cursor to the AUTO SKIP parameter.

2.Select either ON or OFF.

The initial factory setting is ON.

ON: Enables the auto skip function.

OFF: Disables the auto skip function.

Note: The auto skip function is not available when play- ing back pictures.

15