Panasonic WV-BP550 manual Motion Detector Setting Motion DET

(FINE adjustment can be made up to 22.5 degrees

by pressing or .)

Notes:

•When the “I” cursor reaches the “+” end, it jumps back to “−”. At the same time, COARSE is incremented by one step to enable a contin-

uous adjustment. The reverse takes place when the “I” cursor reaches the “−” end.

•When or is kept pressed for a second or longer, the “I” cursor moves faster.

•To reset COARSE and FINE to the values pre-

set at the factory, press or simultane- ously. COARSE and FINE adjustments are preset at the factory to zero-crossing of the AC line phase.

•If the AC line contains noise (spike noise, etc.), the stability of the vertical phase of the camera video output signal may be disturbed.

7.Motion Detector Setting (MOTION DET)

The motion detector detects the moving objects in the scene by monitoring the brightness level changes. You can select the level of sensitivity for motion detection.

When this camera is connected to a compatible intelli- gent CCTV system, the camera transmits an alarm sig- nal by multiplexing it with the video signal.

1.Move the cursor to the MOTION DET parameter and select ON.

2.Press . The MOTION DETECT menu appears on the monitor screen.

** CAM SET UP **				** MOTION DETECT **
CAMERA ID		OFF	↵	LEVEL	....I....
ALC/ELC		ALC	↵
SHUTTER		---		DISPLAY MODE↵	-	+
AGC		ON
SENS UP		OFF		ALARM	ON
SYNC		INT
MOTION DET		ON	↵	MASK SET ↵
LENS DRIVE		DC
END	SET UP ENABLE			RET END

3.Move the cursor to MASK SET and press . The MASK SET menu has 48 masks. To set MASK SET, proceed as described in steps 2 to 4 of “ALC mode with SUPER-D OFF and ELC mode” on page 22.

4.Move the cursor to the ALARM parameter and select ON or OFF to set the alarm in the DISPLAY MODE.

Note: When the system controller WV-RM70, WV- CU550 or WV-CU550A is used with this model, select OFF for ALARM.

5.Move the cursor to DISPLAY MODE and press to see the current setting. The masks that detect the brightness changes start blinking.

-28-