Installation of Auto Iris Lens Connector

Install the lens connector (YFE4191J100) when using a video drive ALC lens.

The installation should be made by qualified ser- vice personnel or system installers.

(1)Cut the iris control cable at the edge of the lens connector to remove the existing lens connector and then remove the outer cable cover as shown in the diagram below.

The pin assignment of the lens connector is as fol- lows:

Pin 1: Power source; +9V DC, 50mA Max.

Pin 2: Not used

Pin 3: Video signal; 1.3 V[p-p]/40 kΩ

Pin 4: Shield, ground

Rib

Pin 3

Pin 1

Pin 4

Pin 2

(2)After connection, assemble the lens connector as follows.

Connector

CoverAutomatic

Iris Lens

Heat

Shrinkable

Tubes

Iris Control

Cable

Connector

Note: When the iris control cable is too thick to lock the connector cover with the connector base, cut off the rib on the connector.

(Select VIDEO for LENS DRIVE of the CAM SET UP menu.)

-10-

Page 12
Image 12
Panasonic WV-BP554 manual Installation of Auto Iris Lens Connector