Panasonic WV-CM1780 Camera Configuration CAM CON- FIG, Baud Rate Baud Rate, Data Bit Data BIT

●Camera Configuration (CAM CON- FIG)

This item lets you set numbers for the input from sys- tem cameras for RS-485 communication.

1.Move the cursor to CAM CONFIG with the C or D but- ton, then press the - or + button. The CAMERA CONFIG menu shown below will appear on the monitor screen.

COMMUNICATION SETUP

UNIT ADDRESS			1
CAM CONFIG
BAUD RATE			9600
DATA BIT			8
PARITY CHECK			NONE
STOP BIT			1
WAIT TIME			OFF
	SETUP		ENABLE
CAMERA CONFIG
INPUT CH		CAM NO.
A CH
		001
B CH	002
S-VIDEO	003

2.Move the cursor to the input parameter to be edited with the C or D button, then select a number with the

-or + button.

Select a parameter value between 001 and 128.

The factory default setting for each input is shown below.

A CH	001
B CH	002
S-VIDEO	003

Note: Make sure not to assign the same number to more than one system camera for RS-485 commu- nication.

3.Repeat the above procedure to edit other input.

4.After completing the settings, press the MENU button to return to the previous setup menu.

●Baud Rate (BAUD RATE)

This item lets you set the transmission speed for RS-485 communication.

1.Move the cursor to the BAUD RATE parameter with the C or D button.

2.Select the desired transmission speed shown below with the - or + button.

2 400 4 800 9 600 19 200

The factory default setting is 9 600 bps.

●Data Bit (DATA BIT)

This item lets you set the number of data bits for RS-485 communication.

The factory default setting is 8 bit and fixed.

●Parity Check (PARITY CHECK)

This item lets you set the parity bit for RS-485 communica- tion.

1.Move the cursor to the PARITY CHECK parameter with the C or D button.

2.Select NONE, EVEN or ODD for parity check with the - or + button.

The factory default setting is NONE

●Stop Bit (STOP BIT)

This item lets you set the number of stop bits for RS-485 communication.

1.Move the cursor to the STOP BIT parameter with the C or D button.

2.Select either 1 or 2 for number of stop bits with the - or + button.

The factory default setting is 1 bit.

●Wait Time (WAIT TIME)

This item lets you set the waiting time in milli-seconds (ms) to retry after confirming that no data is received from the system controller for RS-485 communication.

1.Move the cursor to the WAIT TIME parameter with the C or D button.

2.Select OFF, 100, 200, 400, 1 000 ms for the wait time with the - or + button.

When no transmission is needed, select OFF. The factory default setting is OFF (no retry).

10