17
<Fine adjustment of the back focus through the setupmenu>
1. Loosen the 1 fixing screw of the rear cover to remove the rear cover.
2. Loosen the 2 fixing screws of the switch cover to remove the switch cover.
3. Hold down the setting button for 2 seconds or more to call up the top screen of the setup menu. And then adjust the
back focus. For further information, refer to page 35.
mMount the cover
1. Attach the desiccant (accessory) to the inner bottom side of the lens cover.
2. Mount the lens cover, switch cover, and rear cover.
Important:
• The tightening torque described below shall be followed for the 2 fixing screws of switch cover and the 4 fixing screws of
lens cover.
Recommended tightening torque: 0.59 N·m {0.44 lbf·ft}
• Be sure to attach the desiccant (accessory). Refer to the instructions for the desiccant for how to attach it.
• The tightening sequence of the 4 fixing screws of the lens cover shall be observed and repeated twice as described in the
illustration above.
((1) →(2) →(3) →(4), twice)
Rear cover Fixing screw x1 Switch cover Fixing screw x2 Set button
Rear coverSwitch cover
Mouning lens cover
(1)(3)
(4)(2)
Mouning switch cover Mouning rear cover
Fixing screw x4 Fixing screw x2 Fixing screw x1