27
•Select a proper "FINE" phase so that the two video signals on the oscilloscope come as close as possible.
Notes:
•Moving the "I" cursor across the +/- end will shift the "FINE" range.
•Press the [LEFT] and [RIGHT] buttons simultaneously to reset the "V PHASE" to the default (0 degree).
•Keep pressing the [LEFT] and [RIGHT] buttons for a second to move the "I" cursor faster if necessary.
•Spike noise if contained in the AC mains may disturb synchronization of LL.
7. White Balance Setting (WHITE BAL)
Select a mode for "WHITE BAL" on the "CAMERA SETUP" menu. The default setting is "ATW1".
ATW1: Is automatically adaptable to the color temperatures of 2 700 K - 6 000 K.
ATW2: Is automatically adaptable to the use of sodium lamps (2 000 K - 6 000 K).
AWC: Is automatically adaptable to the color temperatures of 2 000 K - 10 000 K.
Notes:
•When "ATW1" or "ATW2" is selected, no further operation is required.
•"ATW1" and "ATW2" do not appear on the setup menu of the system controller.
•Select "AWC" in the following cases: the color temperature is out of the 2 000 K - 6 000 K range, the scene contains mostly
high color temperatures such as blue sky or sunset, or the scene is dim.
•When "AWC" is selected, the "AWC" setting is required.

AWC Setting

1. Select "AWC" and press the [LEFT] button.
→"AWC" will change to "AWC →PUSH SW".
2. Press the [SET] button.
→"PUSH SW" will be highlighted while the "AWC" setting is
performed.
Note:
•If the white balance is not set, "PUSH SW" is being highlighted.
3. Press the [RIGHT] button.

Manual Fine Adjustment

Perform fine adjustment as necessary.
1. Select "WHITE BAL" and press the [SET] button.
→Fine adjustment menu of ATW or AWC will open.
2. Adjust finely "R" (Red) and "B" (Blue) gain by moving the "I" cursor.
8. Motion Detection Setting (MOTION DET)
When a series of changes in pictures is detected, the camera outputs an alarm to the external device such as a disk recorder.
The recorder will start recording the pictures.
1. Select a mode for "MOTION DET" on the "CAMERA SETUP" menu.
The default setting is "OFF".
OFF: Disables the alarm output.
MODE1: Outputs alarm when a series of motions is detected.
MODE2: Outputs alarm when a series of scene changes is
detected.
→The "MODE1" menu opens when you select "MODE1" and
press the [SET] button.
2. Adjust for "LEVEL" to optimize the sensitivity of detection.
**ATW1**
R ...I...128
- +
B ...I...128
- +
RET TOP END
** MODE1 **
LEVEL ...I...128
- +
DWELL TIME 2S
DISPLAY MODE
ALARM OFF
MASK SET
RET TOP END