32
FOCUS buttons
BRIGHTNESS buttons
Control pad/buttons
Refer to Operation Instructions for descriptions of how
to operate these buttons/pad.

■Position

[Left position]
Move the camera to the desired point to be set as the
left point of the auto panning using the control pad/but-
tons and adjust the image using the [ZOOM] buttons
and the [FOCUS] buttons.
Then click the [SET] button to register the position as
the left position.
[Right position]
Move the camera to the desired point to be set as the
right point of the auto panning using the control pad/but-
tons, and then click the [SET] button to register the posi-
tion as the right position.
Notes:
•Panning, tilting and zooming operations can also be
carried out on the [Image/Position] tab.
•Adjusted zoom and focus position for the auto pan
function will be applied when [SET] button of "Start
position" is clicked. These adjustments will not be
applied by clicking the [SET] button of "End posi-
tion".

■Auto pan

[Dwell time]
Select a dwell time at the left position and the right posi-
tion from the following.
5 sec/10 sec/20 sec/30 sec
Default: 5 sec
[Speed]
Select a speed for the auto panning from the following.
3°/sec, 4°/sec, 5°/sec, 7°/sec, 10°/sec, 13°/sec,
18°/sec, 24°/sec
Default: 13°/sec
Note:
Even when the selected zoom factor is higher than
30x, the camera will start panning with 30x zoom
factor.
Important:
•When "Dwell time" or "Speed" is edited, it is neces-
sary to click the [SET] button to apply them.
•If these settings were configured during the auto pan
operation, stop the auto panning once and resume
the auto panning again.
ZOOM buttons
FOCUS buttons
BRIGHTNESS buttons
Panning, tilting and zooming operations can also be car-
ried out on the [Image/Position] tab.
[CLOSE] button
Click this button to close the "Preset No." setup menu.
Configure the settings relating to the auto pan function ("Auto Pan" setup menu)
Click the [SETUP>>] button of "Auto Pan" on the [Image/Position] tab of the "Camera setup" page. (☞page 25)
The settings relating to the auto pan function can be configured with the setup menu displayed in a newly displayed
window.