ParaBody 445104 manual Purchased refer to the 359101 Assemblyinstructions now

9

1

4

10

14 3/8 X 1-1/4”

2

16

7

18

BASE

8

15

3

9

FIGURE 15

STEP 15

• Insert four CAP PLUGS (9) into the top and bottom ends of the GUIDERODS (1) as shown in FIGURE 15.

• SECURELY assemble the WEIGHT STACK SHAFT (2) to the HEAD PLATE (4) using one 3/8 X 1-1/4”	and one 3/8”
WASHER (10).

•Insert two GUIDE RODS (1) into the BASE as shown on FIGURE 15. (NOTE: Lubricate GUIDE RODS (1) with silicon or spray available at most hardware stores.)

•Slide two 1-1/4 SQ. X 4-7/8” TUBES (3), two 3/4” WASHERS (15), and two WEIGHT STACK CUSHIONS (8) - IN THAT

ORDER - down over the GUIDE RODS (1).

•Using EXTREME CARE slide all fifteen WEIGHT PLATES (16) down over the GUIDE RODS (1) on to the WEIGHTSTACK CUSHIONS

(8). Make sure that the keyholes of the WEIGHT PLATES (16) are all facing the right way. (NOTE: If the359101 50 LB. ADD-KIT is

purchased refer to the 359101 ASSEMBLYINSTRUCTIONS now.)

• Slide the head plate assembly down over the GUIDE RODS (1) onto the weight stack.

• Attach the WEIGHT STACK LABELS (18) to the weight stack. Also insert the WEIGHT STACK PIN (7) into the first WEIGHT PLATE (16) of the weight stack.

11