ParaBody 445104 manual Press-Stack

FIGURE 11
	PRESS-STACK
		CABLE
	5	(67475)
PRESS-STACK
CABLE
(67475)	5

STEP 11

•Route the new PRESS-STACK CABLE (5) around the pulleys and l-brackets as shown in STEP 11. (Remove pulleys for ease of installation.)

FIGURE 12

PRESS-

STACK

CABLE

(67475)

5

9

STEP 12

•To assemble the PRESS-STACK CABLE (5) follow the cable routing as shown and use the following steps:

•Route the thread end of PRESS-STACK CABLE (5) up and over the PULLEY in the TOP BOOM above the WEIGHT STACK. (Remove pulley for ease of installation.)

•Screw the threaded end of the PRESS-STACK CABLE

(5) approximately 1” into the end of the SELECTOR SHAFT of the HEAD PLATE on the WEIGHT STACK as shown in FIGURE 12.

•SECURELY tighten the pulley connection from the previous step.