FIGURE 15 |
|
23 |
|
TIGHTEN! | |
| 3 |
| ADJUSTMENT |
6 | 20 |
| |
| ADJUSTMENT |
STEP 15:
•SECURELY tighten all loose frame connections.
•Slide the SHAFT COLLARS (23) to the top of the GUIDE RODS (3) and tighten set screws as shown in FIGURE 15.
•Adjustments can be made in the above locations to set the correct amount of tension in the cables. (NOTE: FLOATING PULLEYS should rest against the stops.)
•If upon completion of assembly, the HEAD PLATE (6) does not sit on top of the first WEIGHT PLATE (20), push the HEAD PLATE (6) down, insert the WEIGHT STACK PIN (10) and perform several repetitions. This will relax the cable system and prevent the HEAD PLATE (6) from lifting up. See FIGURE 15.
•For maximum performance, the HEAD PLATE (6) should just barely sit on the top WEIGHT PLATE (20).
•NOTE: After making adjustments make sure all jam nuts are SECURELY TIGHTENED!
•This completes the assembly of the 880 SECOND STACK OPTION. If the 880 SHROUD OPTION was purchased refer to the 880 SHROUD KIT assembly instructions.
Thank you for purchasing the ParaBody 880 Gym System. If unsure of proper use of equipment, call your local ParaBody distributor or call the ParaBody customer service department at (800)
15
