7 |
FIGURE 19 |
STEP 19:
•Route the new PRESS STACK CABLE (7) thru the REAR UPRIGHT as shown. (NOTE: Remove pulleys for ease of installa- tion.) Slide GUIDE RODS up just enough to get the cable end thru. Push GUIDE RODS down when finished.
STEP 20:
•Route the new PRESS STACK CABLE (7) around the pulleys in the BOOM BRACKET using the existing bolts as shown in FIGURE 20. (NOTE: Make sure the cable runs in the grooves of the pulleys.)
•Screw the threaded end of the PRESS STACK CABLE (7) into the end of the HEAD PLATE. See FIGURE 20.
FIGURE 20 |
BOOM |
BRACKET |
7 |
HEAD |
PLATE |
28 |
