2.Detach the hook-and-loop fastener strap from the female RJ21 connector port: lift the hook-and-loop fastener tab on the left and pull the strap open towards the right, leaving it looped under the right side of the connector frame.
FEMALE RJ21 CONNECTOR A
FOR INTERFACE MODULE SLOT 3
3.Slide the male RJ21 connector of your interface cable underneath the hook-and-loop fastener, from the bottom, and press it firmly into the female RJ21 connector port on the chassis.
MALE RJ21 CONNECTOR OF
YOUR INTERFACE CABLE
4.Pull the hook-and-loop fastener strap to the right, making sure that it is snug against the connector, then pull the strap back towards the left, such that the hook-and-loop fastener layers stick to one another across the top of the connector. Tuck the tab at the end of the strap down to the left of the connector frame so that it is out of the way of other connections and then screw the top of the RJ21 cable connector into the jack screw at the top of the RJ21 connector frame on the chassis. Note: If you are using a 120 or 180 degree cable, both the top and the bottom of the cable connector should be screwed to the RJ21 connector frame on the chassis.
16 | July 2005 | IPD1-A2-GZ40-10 |
