Call Setup Branch
10-33910-A2-GN32-40 September 1998
Once the directory location you want appears on the LCD, press the F2 or F3 key to dial the
number.
F1
DialDirectory:01
Off Hook
F2 F3
The Call Setup status Off Hook appears during the connection process. If the connection is
successful, one of the Normal Operation status messages (Table 3-3 in Chapter 3, DCP
Operation) appears on the LCD. If the connection is not successful, the LCD displays one of the
Call Failure status messages (Table 3-3 in Chapter 3, DCP Operation).
Disconnect
For dial backup applications, use this function when you want to disconnect an established call
on a dial line. For leased backup applications, use this function to switch between the primary
leased line and the backup leased line.
To access Disconnect from the Call Setup branch, make the following selection:
F1
Call Setup: >
Dial Disconnect
F2 F3
Select Disconnect.
F1
Disconnect
Command Complete
F2 F3
For dial backup applications, the modem goes on-hook (hangs up) and the call is disconnected.
The Command Complete status message appears.
To exit this function and remain in the Call Setup branch, press the key. To exit and return
to the Top-Level menu, press the key.