COMSPHERE 3900 Series Modems
11-2 September 1998 3910-A2-GN32-40
Manual Dialing When the Remote Modem is Configured forAuto-Answer
NOTE
On the remote modem, the Line Current Disconnect configuration
option (refer to Line Dialer in Chapter 5, DCP Configuration) must
be set to Disable.
This configuration option does not appear on Models 3910-A1-401
and 3911-B1-001.
If you are originating a call using a telephone and the remote modem is configured for
Auto-Answer, perform the following procedure.
F1
Idle:19.2
Tlk/Data
F2 F3
Press the key until Tlk/Data appears.
Lift the attached handset and dial the telephone number of the remote modem. When the remote
modem answers, it transmits an answer tone.
F1
Idle:19.2
Tlk/Data
F2 F3
When you hear this tone, immediately select Tlk/Data and hang up the handset. This starts the
handshaking sequence between your modem and the remote modem.
F1
Online:19.2 >
Call_Setup
F2 F3
If this is successful, the modems are in Data mode and OnLine appears on the LCD.