DCP Operation
3-113910-A2-GN32-40 September 1998
Table 3-3
(3 of 3)
Top-Level Menu Status
Status IndicatesMessage
Call Disconnect ATH Disconnect The modem has disconnected due to an ATH command.
Bad Lines Disc The modem has disconnected because the lines do not support the
modulation and/or data rate selected.
No Carrier Disc The modem disconnects due to the loss of carrier signal from the
remote modem.
DTR
Disconnect The modem has disconnected due to the loss of DTR from the DTE.
EC Disconnect The modem has disconnected due to failure to negotiate Error
Control mode.
Inv Rate Disc When using V.32bis modulation, the remote modem does not
support the data rate used by the local modem.
LnCurrnt Disc The modem has disconnected due to the loss of line current.
LongSpace
Disc The modem has disconnected due to the detection of a long space.
NoData Disc The modem has disconnected due to a lack of transmitted and
received data.
Disconnecting The modem has begun the disconnect sequence.
RmtCmnded
Disc The modem has disconnected due to a V.32 Cleardown received
from the remote modem.
Talk Mode The modem is in Talk mode.
Firmware
Download
Result
DownldOnly
Mode A local download of firmware or a remote cloning of firmware has
failed. The modem is currently in a Download Only mode in which
only another download attempt is possible.
Frmware
Upgrade A local download of firmware or a remote cloning of firmware was
successful.
RemClone
Failed A remote cloning of firmware has failed. This message appears on
the local modem’s LCD.
Firmware
Download
Result
Cont.
Remote Clone
OK A remote cloning of firmware was successful. This message
appears on the local modem’s LCD.
Bcast Clone
Done A broadcast cloning of firmware has completed. You must look
under the Control branch for cloning results. This message appears
on the local modem’s LCD.
AT Command
Reset Reset by AT
command The modem has performed a reset in response to an ATZ
command.