Paradyne 9820, 9820-2M, 9820-8M, and 9820-45M Controlling Telnet or FTP Access

Security and Logins
5-5
9820-A2-GB20-20 June 2000
Controlling Telnet or FTP Access
The FrameSaver unit provides several methods for limiting access via a Telnet or
FTP session. Telnet or FTP access can be on a standard management link or on
a service provider’s troubleshooting (TS) management link.
Limiting Telnet Access
Telnet access can be limited by:
HDisabling Telnet access completely.
HRequiring a login for Telnet sessions that are not on the TS Management
Link.
HAssigning an access level for Telnet sessions.
HDisabling TS Management Link access.
To limit Telnet access via a service provider’s troubleshooting management link,
see
Limiting Telnet or FTP Access Over the TS Management Link .
"Procedure
To limit Telnet access when the session is not on the TS Management Link:
1. Select the Telnet and FTP Session options.
Main Menu → Configuration → Management and Communication →
Telnet and FTP Sessions
2. Set the following configuration options, as appropriate.
To . . . Set the configuration option . . .
Disable Telnet access Telnet Session to Disable.
Require a login Login Required to Enable.
NOTE: User ID and password combinations
must be defined. See
Creating a Login .
Assign an access level Session Access Level to Level-2 or Level-3.
NOTE: Regardless of a user’s login access
level, a user cannot operate at a level higher
than the access level specified for the Telnet
session (e.g., if a user has a Level-1 login and
Level-2 telnet access has been set, the
Level-1 user can only operate as a Level-2
user).
If you are going to allow users to configure the
unit, keep the access at Level-1.
3. Save your changes.
See Configuring Telnet and/or FTP Session Support in Chapter 4, Configuration
Options,
for more information about setting Telnet configuration options.