Parker Hannifin PA Series manual System Configuration Files, CONFIG.SYS File, AUTOEXEC.BAT File

Appendix B: System Configuration Files System Configuration Files

System Configuration Files

Parker includes backup copies of the CONFIG.SYS file and AUTOEXEC.BAT file in the \CTCTEMP directory on your PowerStation’s Compact Flash disk and on the PowerStation Start disk. These files are called CONFIG.CTC and

AUTOEXEC.CTC.

CONFIG.SYS File

SHELL=C:\COMMAND.COM /E:1024 /P

FILES=30

BUFFERS=30

STACKS=9,256

DEVICE=C:\DOS\HIMEM.SYS

DOS=HIGH,UMB

REM

REM !!! NOTE !!!

REM EMM386 can be used to free up more conventional memory for use by

REM Interact, by allowing TSRs to be loaded high. Just remove the word

REM 'REM' in front of the appropriate command, and adjust the

REM parameters as required for your system's configuration.

REM

REM DEVICE=C:\DOS\EMM386.EXE NOEMS

REM

REM IMPORTANT: Always include the NOEMS switch when using

REM EMM386 with Interact.

REM

AUTOEXEC.BAT File

The lines in the following table must appear in the PA PowerStation’s AUTOEXEC.BAT file for the unit to operate properly. The AUTOEXEC.BAT file that Parker supplies includes these lines and is located in the \CTCTEMP directory on the PowerStation’s Compact Flash card in a file called

AUTOEXEC.CTC.

Please make sure that the AUTOEXEC.BAT file on your PA PowerStation’s CF card includes the command lines shown in table B-1. A complete listing of the AUTOEXEC.BAT file is shown after table B-1.

Table B-1: Autoexec.bat Command Line Parameters

Command Line Parameters	Description
PATH C:\; C:\DOS; C:\CTC	Sets up the default DOS path.
LH C:\CTC\BIOSTSR	Loads special functions.
C:\CTC\PACTRL -A -S	Verifies this CompactFlash is running on a
IF ERRORLEVEL 108 GO TO	PowerStation.
ERROR
CD \CTC	Required for the MachineShop Shell to
IF EXIST C:\CTC\MOUSE.INI DEL	detect a mouse in some situations.
C:\CTC\MOUSE.INI

PA PowerStation User Guide B-2