Before first use
1.Insert the battery pack 7 into the quick- charger 10 (see Fig. C).
2.Insert the power plug into the socket. The now glowing red charging control LED 12 indicates that the charging process has begun. The red charging control LED 12 extinguishes as soon as the battery pack is fully charged.
3.The green charging control LED 11 signals to you that the charging process is complete and the battery pack 7 is ready for service.
Never charge the battery pack for a second time immediately after a fast charging process has been completed. This can give rise to the battery pack becoming overcharged and to a reduced service life of the battery and charging station. Switch the charger off for at least 15 minutes between two successive charging procedures. Remove the power plug from the wall socket.
RED / ORANGE = medium charge / capacity RED = weak charge – recharge battery
Changing tools
Your cordless electric drill / screwdriver has a fully
automatic spindle lock 
and is fitted with an enclosed keyless chuck incorporating the latest
technology from 
”Made in Germany”.
Once the motor has come to a halt, the drive shaft is automatically locked, so that the chuck 9 can
be opened simply by turning it 
.
After you have inserted the required bit and fixed it
in place by turning the chuck 
, you can immedi- ately continue working. The spindle lock releases itself automatically when the motor is started (by operation of the ON / OFF switch 4 ).
Insertion / removal of a battery pack into the appliance
Ensure that the appliance is switched off before in- serting the battery. The insertion of a battery into an electrical appliance that is switched on can lead to accidents.
Inserting the battery pack:
Bring the rotation direction switch 3 into the middle position (Locked) and insert the battery pack 7 into the handle until it engages.
Removing the rechargeable battery pack: Press the release button 6 and remove the rechargeable battery pack
Torque pre-selection
You can adjust the torque by using 8 torque pre- selection. The torque levels regulate a range of up to ca. 8 Nm.
Select a low setting for small screws, soft work material.
Select a high setting for large screws, hard work materials and for the extraction of screws. For drilling, push the selector to the setting for drilling, in that you adjust the torque 
.
For drilling tasks, also push the gear selector switch 1 to the front (Position: 2).
Checking battery status | 2 Gear Drive |
To check the battery status, press the battery LED button 2 (see also Fig.). The status or re- sidual capacity will be indicated in the battery LED 2 as follows:
GREEN / RED / ORANGE = maximum charge / capacity
CAUTION! Move the gear selector switch 1 only after the device has come to a standstill. Failure to observe this advice may result in damage to the device.
GB 11
