Patton electronic 2168B user manual Configuring DIP Switch S1, Operation, Power UP

4.2 CONFIGURING DIP SWITCH S1

DIP switch S1 is where you configure the CopperLINK line. The following tables describe the configuration for the 2168B.

Table 1: 2168B Firmware Configuration

			S1-1		S1-2		S1-3		S1-4
Position
		Master/					Rate
			Slave
ON			Slave
			(CPE)		4/1, 9/1, 16/2, 6/6, 10/10, 15/15
OFF			Master		Rate Control (See table below).
			(CO)
	S1-2			S1-3		S1-4		Rate
								(DS/US)*
	OFF			OFF		OFF		4/1
	ON			OFF		OFF		9/1
	OFF			ON		OFF		16/2
	ON			ON		OFF		6/6
	OFF			OFF		ON		10/10
	ON			ON		ON		15/15

*. DS = Downstream, US = Upstream

5.0 OPERATION

Once the Model 2168Bs are properly installed, they should operate transparently. No user settings required. This section describes reading the LED status monitors.

5.1 POWER UP

Before applying power to the Model 2168B, please review section 3.3, “Connecting Power” on page 12 to verify that the unit is connected to the appropriate power source.

14