DC Power, Ton.com, for more information | Patton electronic 2701/D

DC Power

The 36–60 VDC DC to DC adapter supplied with the DC version of the Model 2701 plugs in a DC source (nominal 48 VDC) and plugs into the barrel power supply jack on the rear of the 2701. Refer to Figure 5 to make the proper connection.

Figure 5. Connecting DC Power to the 2701 DC Power Supply.

	There are no user-serviceable parts in the
	power supply section of the Model 2701. Con-
	tact Patton Electronics Technical support at
	(301)975-1007, via our web site at http://
	www.patton.com, or by e-mail at support@pat-
WARNING	ton.com, for more information.

Page 16

Image 16

Patton electronic 2701/D DC Power, There are no user-serviceable parts, Power supply section of the Model 2701. Con

Contents

User Manual Contents Page Radio and TV Interference Warranty InformationCE Notice Service Tel +1 301 Email support@patton.com General Information FeaturesDescription Configuration DIP Switch Configuration SW1 SW2 SW3 SW4 SW5 Switch SW1-1 through SW1-5Speed SW1-6 SW1-7 Clock Mode SW1-6 and SW1-7 Clock Modes SW1-8 Enable/Disable Loop Tests from DTE S1-8 SettingPosition Function Factory Default Selected Option Switch SW2-1 Line Coding HDB3 default Switch SW2-2 CRC-4 Multiframe Switch SW2-3 Data InversionSW2-2 Option SW2-3 Option Switch SW2-4 Remote Digital Loopback Type Switch SW2-5 Front Panel SwitchesSwitch SW2-6 V.54 Response Disabled default S2-4 RDL Type Installation Connecting to the G.703 NetworkConnecting the Twisted Pair 120 ohm to the G.703 Network Opening the Case Connecting the Serial Port Connecting to a DTE Device Connecting to a DCE Device Power ConnectionUniversal AC Power 100-240 VAC Conﬁguring the X.21 Interface 2701/D DC Power There are no user-serviceable partsPower supply section of the Model 2701. Con Tact Patton Electronics Technical support at POWER-UP OperationLED Status Monitors TD & RD Loop V.54 & Telco Diagnostics Operating Local Loopback LL Operating Remote Digital Loopback RL Remote Loop in a Network Extension Application Using the V.52 BER Test Pattern Generator CSU Loop Network Connector Appendix aNetwork Data Rate Nominal Impedance Power Supply TemperatureDimensions Humidity Appendix B Page Interface 34F Female Connector DCE Conﬁguration Pin # Signal Appendix CPage Appendix D Appendix E Patton Model # Description

Patton electronic 2701/D, 2701/B, 2701/C user manual DC Power, There are no user-serviceable parts

Models: 2701/C 2701/D 2701/B

DC Power

Figure 5. Connecting DC Power to the 2701 DC Power Supply.

There are no user-serviceable parts in the

power supply section of the Model 2701. Con-

tact Patton Electronics Technical support at

(301)975-1007, via our web site at http://

ton.com, for more information.