Model 2977 DialFire RAS User Manual | 2 • Preparation |
|
|
DialFire PTE ISDN E1 (Euro ISDN) Configuration Worksheet
Use the worksheet below to collect the information that may be required to complete the configuration of your DialFire PTE adapter within your operating system environment.
Note Not all operating systems support all parameters.
Note The parameters on this page are for ISDN E1 (Euro ISDN).
Parameter |
|
| Value | |
|
|
|
| |
Line Type | E1 |
|
| |
Framing | [ ] CEPT with CRC4 | [ ] CEPT without CRC4 | ||
|
|
| ||
Coding | [ ] HDB3 [ ] AMI |
| ||
Signaling | [ ] ETSI (Euro ISDN) | [ ] None | ||
|
| |||
Leased Time Slots | List which, if any, E1 time slots are leased: | |||
|
| |||
Modem Nationality | Enter the country in which the PTE adapter will be operated: | |||
|
| |||
Before You Install the DialFire | Order the ISDN Line | |||
RAS B4ST Adapter… | If you do not have an ISDN line installed, you need to contact your tele- | |||
. | ||||
phone company and order a Basic Rate ISDN line (2B+D) with the follow- | ||||
| ||||
| ing recommended configuration: | |||
|
| Note If your telephone company supports either of the | ||
|
| following ISDN Ordering Codes, request that your | ||
|
| ISDN line be configured to one of them. | ||
| • | |||
| • | Capability S |
| |
| If your telephone company does not support either of these Ordering | |||
| Codes, request the following ISDN line configuration: | |||
| • Switch Type: National ISDN 1 (preferred), ETSI, AT&T 5ESS, or Nortel | |||
|
| DMS 100 |
| |
| • ISDN Basic Rate Interface (BRI) service (2B+D) | |||
| • 2 B channels, D channel for signaling only (no D channel packet data) | |||
| • Circuit Switched data and voice (CSD/CSV) on each channel | |||
| • | Dynamic TEI |
| |
| • | Multipoint bus configuration | ||
| • Terminal type A (AT&T Custom switch only) | |||
| • No EKTS or special services or features | |||
| *You must select a long distance carrier and forward your choice, along with the Ordering | |||
| Code or line configuration, to your telephone company | |||
|
|
|
| |
After completing the worksheet, go to section chapter 3, “Installing the Model 2977 adapter” on page 26.
DialFire PTE ISDN E1 (Euro ISDN) Configuration Worksheet | 21 |
