Model 2977 DialFire RAS User Manual | 3 • Installing the Model 2977 adapter |
|
|
9.Replace the computer’s cover.
10.Connect the telephone line(s) to the adapter (see figure 3 on page 28 for connector locations). Adapter installation is complete. Refer to Chapter 4, “Driver installation and configuration”.
Model 2977 B4 U adapter installation
The DialFire RAS B4ST adapter provides four ISDN Basic Rate Interface (2B+D) lines in a package that fits in a single PCI slot in your server.
This section describes how to install your DialFire RAS B4ST adapter.
Do the following:
1.Unplug power from the computer.
2.Remove the computer’s cover.
3.Put on the wrist strap (included in your DialFire RAS package) and attach it to the computer’s chassis.
To guard against damage to the DialFire RAS adapter due to electrostatic discharge (ESD), do not remove the adapter from its protective packaging until you have grounded yourself to the computer chassis
4.Locate an available
5.Remove the DialFire RAS adapter from its protective packaging.
6.Write down the serial number of the adapter in the space provided below. The serial number label has the general form: “S/N (S) XXX XXXXX”
Serial Number: ________________________
7.Insert the adapter into the slot and screw the endplate to the computer chassis. The endplate must be screwed into the computer chassis to remain in compliance with Part 15 of FCC rules.
8.Replace the computer’s cover.
Model 2977 B4 U adapter installation | 29 |
