Configuring the RAS with a Web browser 43
Model 2960/2996 RAS User Manual 3 • Configuring the RAS for operation
Note
The information entered into the Interregister S ignaling section must
match the information the telco provided. If the information entered
is not the same, the RAS may not answer calls. In some installations,
the phone company will send a special tone to alert that it is done
sending the Calling Number. In this case, the value in the Total Dig-
its box does not have to match the telephone company’s exactly.
Channel assignment
This section describes configuring the RAS so it will know which channels are active. Do the following:
1. Select
T1/E1 Link
on the
Configuration Menu
. The T1/E1 Link Activity window appears (see figure 28 on
page 39).
2. Click on
Channel Assignment
. The WAN Circuit Channel Assignment window appears (see figure 33).
Figure 33. WAN Circuit Channel Assignment window
3. Click on the
Dialin
button located under
Set all channels to:
.
4. Click on
Submit Query
.
Configuring line settings and signaling for T1
1. Select
T1/E1 Link
on the
Configuration Menu
. The T1/E1 Link Activity window appears (see figure 28 on
page 39).
2.
Link: 1
corresponds to Line 1 on the RAS. This is the primary link for dial-in callers. Under Link 1, Click
on
Configuration
then
Modify
. The Line Interface Settings section of the WAN Circuit Configuration
window appears (see figure 29 on page 39).
Configuring the line settings
1. Click on the
Line Type
pop-up menu (see figure 29 on page 39) and choose from the following options:
– dsx1ESF Extended SuperFrame DS1