Patton electronic 4110 manual Connect the SmartNode to the network, Load configuration

Model 4520 & 4110 Series Getting Started Guide 4 • Getting started with the SmartNode

2. Connect the SmartNode to the network

Depending whether you connect the SmartNode to a host directly or via a hub or switch either straight- through wired or cross-over cables must be used (see figure 22).

Note The SmartNode 4520 Series is equipped with Auto-MDX Ethernet ports.

Use straight-through or cross-over cables for host or hub/switch connections.

The SmartNode 4110 will require the proper cable as it does not have the

MDX feature.

Figure 22. Connecting the SmartNode to the network

You can check the connection with the ping command to another host on the local LAN.

172.16.1.99(if-ip)[eth0]#ping <IP Address of the host>

Respectively from the host: ping 172.16.1.99

Note To ping outside your local LAN, you will need to configure the default gateway.

3. Load configuration

Download a configuration note to your PC from the support page of the Patton-Inalp web server (http://www.inalp.ch/en/support/confignotes/), which matches your application. Adapt the configuration as described in the configuration note to your network (do not forget to modify the IP address) and copy the modified configuration to a TFTP server. The SmartNode can now load its configuration from this server.

In this example we assume the TFTP server on the host with the IP address 172.16.1.11 and the configuration named SN.cfg in the root directory of the TFTP server.

172.16.1.99(if-ip)[eth0]#copy tftp://172.16.1.11/SN.cfg startup-config

Download...100%

172.16.1.99(if-ip)[eth0]#

After the SmartNode has been rebooted the new start up configuration will be activated.

172.16.1.99(if-ip)[eth0]#reload Running configuration has been changed.

Do you want to copy the ’running-config’ to the ’startup-config’?

Press ’yes’ to store, ’no’ to drop changes : no

2. Connect the SmartNode to the network 45