![](/images/new-backgrounds/1195239/19523911x1.webp)
4.1.2 | Installing the New QuickConnect™ Module |
1) | Make sure the power switch on the base unit is off. Leave the |
| power cord plugged into a grounded outlet to keep the unit |
| grounded. |
4.2 CONNECTING TO THE 10BASE-T ETHERNET PORT
The
directly to a 10BaseT network. Figure 5, below, shows the 10BaseT
2) | Hold the module with the faceplate toward you and align the |
| module with the guide slots in the rear panel of the base unit. |
3) | While keeping the module’s faceplate parallel with the base unit |
| rear panel, slide the module straight |
| contacts line up with the socket inside the chassis. Figure 4 |
| (below) shows how a Quick Connect Module plugs into the rear |
| of the base unit. |
using Type 4 or 5 cable.
1
2
3
4
5
6
7
8
1 RD+ (data input to IM1/I4)
2 RD- (data input to IM1/I4)
3 TD+ (data output from IM1/I4)
4 (no connection)
5 (no connection)
6 TD- (data output from IM1/I4)
7 (no connection)
8 (no connection)
Figure 4. Installation of Model IM1/I4 Plug-in Serial Interface Module
NOTE: The card edge connector should meet the socket when it is almost all the way into the chassis. If you encounter a lot of resistance, remove the module and repeat steps 2 & 3.
4)With the card edge contacts aligned with the socket, firmly seat the module by using your thumbs to apply pressure directly to the right and left edges of the module faceplate. Applying mod- erate and even pressure should be sufficient to seat the mod- ule. You should hear it “click” into place.
5)To secure the module in place, push the thumbscrews into the chassis and turn the screws clockwise to tighten.
Figure 5. 10BaseT RJ-45 Port Pin Description
4.2.1 Connecting the Hub Ports to Workstations
The Model IM1/I4
IM1/I4 | 10BaseT Workstation | ||
1 | (RD+) | 1 | (TD+) |
2 | 2 | ||
3 | (TD+) | 3 | (RD+) |
6 | 6 |
4.2.2 Connecting the Hub Ports to a Hub (DCE)
The Model IM1/I4
IM1/I4 | Hub | ||
1 | (RD+) | 1 | (RD+) |
2 | 2 | ||
3 | (TD+) | 3 | (TD+) |
6 | 6 |
9 | 10 |