E r a t i n g R F l i n k, Rascal Printers

Rascal Printers

To link a Rascal printer to a data collection terminal:

1.Turn the printer, terminal, and the RF link modules off.

2.Turn on the printer.

3.Turn on the printer's RF link module. The green LED turns on.

4.Turn on the terminal's RF link module. The green LED turns on. Then the LEDs on both modules start blinking.

5.Turn on the terminal.

To operate RF link:

1.Initialize the printer/terminal connection (see "Linking RF link" for more information).

2.Use the printer and the terminal as you normally would.

NOTE: You can walk out of the 3-meter range and scan up to 4 items. When you walk back into the 3-meter range, the printer prints those labels.

There are no software configurations or commands to change the operating parameters.