Renegade 4 Printers with Internal Modules | Paxar 7400 guide

Renegade 4 Printers with Internal Modules

To link a Renegade 4 printer (with an internal RF link module) to a data collection terminal:

1.Turn the printer, terminal, and the RF link modules off.

2.Turn on the printer. The green LED on the side of the printer turns on.

3.Wait for the printer's LED (near the trigger) to blink once.

4.Turn on the terminal's RF link module. The green LED turns on. Then, the LEDs on both modules start blinking.

5.Turn on the terminal.

RF link Operating Instructions 9

Image 9

Paxar 7400 manual Renegade 4 Printers with Internal Modules

Contents

P a c k i n g R F l i n k L I N K O P E R a T I N G S T R U C T I O N S D u l e / U n i t D i a g r a m s LDT/LRT 3800 and PDT Install i n g R F l i n k M o d u l e s PDT RF link Operating Instructions Printer Printers Inserting Batteries N k i n g R F l i n k U n i t s Sierra Sport 2 Printers Renegade 4 Printers with Internal Modules Renegade 4 Printers with External Modules Rascal Printers E r a t i n g R F l i n k Printer Power Source Battery LifeW e r i n g R F l i n k M o v i n g R F l i n k M o d u l e s Troubleshooting Returning RF link to Monarch Page Canadian D.O.C. Warning