Inserting Batteries
To insert a battery into the external RF link module:
1.Carefully slide the battery door (located on the bottom of the terminal module and the
2.Open the door to the left. It does not detach from the module.
3.Keeping the door pulled out, insert the battery in the compartment. Orient the battery so the top faces right, and the + contact (the smaller one) faces up.
4.Close the door.
L i n k i n g R F l i n k U n i t s
Link procedures vary, depending on the printer you are using and whether the module is internal or external.
Before linking any units, set the communication parameters on the data collection terminal to:
♦DTR flow control
♦8 data bits
♦No parity
♦9600 baud
♦1 stop bit.
See the data collection terminal’s documentation to learn how to set these parameters.
