Peavey BAM 210 operation manual BAM Specifications

BAM™ SPECIFICATIONS

SYSTEM SPECIFICATIONS:

GENERAL:

•Mains circuit breaker: 6 amps (resettable)

•Power consumption: 500 Watts, 120 VAC 60 Hz

•Power consumption: 500 Watts, 230 VAC 50/60 Hz

•Hum and noise: Typically greater than -80 dB unweighted

•Internal speakers: Two professional 10 inch cast frame

8-Ohm speakers wired in parallel for a total impedance of 4 Ohms. One Foster compression horn with crossover and tweeter protection.

DIMENSIONS:

•Height: 24 inches (including feet)

•Width: 23.5 inches

•Depth: 17.125 inches @ bottom, 13 inches @ top

•Weight: 93.5 lbs

POWER AMPLIFIER SECTION:

PROTECTION:

•Current limit protection circuit

•Thermal protection circuit

•D.C. crowbar

•DDT™ speaker protection circuit with defeat switch

•Variable speed fan, thermally controlled

GENERAL INFO:

•Minimum load = 2 Ohms

•DDT dynamic range: +16 dB

•Input sensitivity: 1.0 V RMS

•One 1/4 inch external speaker jack

POWER AMPLIFIER INPUT:

•Input impedance: 15 k Ohms

•Sensitivity: 1 V RMS (to drive power amp to clipping)

•Switching jack provides preamp out to power amp in connection when not used

POWER OUTPUT:

•500 Watts (31.62 V RMS) into 2 Ohms with no more than 1% THD+N

•350 Watts (37.42 V RMS) into 4 Ohms with no more than 1% THD+N

HUM AND NOISE:

•Typically greater than 100 dB below full power @ 4 Ohms unweighted

FREQUENCY RESPONSE:

•+0/-1 dB, 100 mW to 300 W RMS 20 Hz to 20 kHz into 4 Ohms

PREAMPLIFIER SECTION:

D/A AND A/D CONVERSION:

•Rate: 44.1 kHz

•Quantization: 24 bit

SETTINGS FOR FOLLOWING MEASUREMENTS UNLESS OTHERWISE NOTED:

•Input trim set to highest level without triggering red clip indicator

•Compressor = Out

•Pre-gain = Not applicable to this model

•Bass = 0 (12 o’clock)

•Mid = 0 (12 o’clock)

•Mid-shift = 0 (12 o’clock)

•High = 0 (12 o’clock)

•Post-gain = 5

•Effects = Off

•Amp model = RED

•Speaker model = BAM 210

INPUT SENSITIVITY (Level to achieve full power):

•Nominal input: 300 mV RMS

•Minimum input: 25 mV RMS (input trim, post-gain and master fully CW)

•Maximum input: 7 V RMS (maximum signal at input before preamp clipping occurs)

PREAMP OUTPUT:

•Nominal output level: 1 V RMS

•Load impedance: 1,000 Ohms minimum

EXTERNAL FOOTSWITCH FUNCTIONS:

•Preset/bank selection

•Remote tuner access/display

•Tweeter on/off selection

•Effects on/off selection

•Effects alternate settings

•Compressor on/off

•Boost function (Allows alternate level and EQ settings)

Specifications are subject to change without notice.

78