Peavey CS2000H, 12/0280304941 manual CS 2000H

CS® 2000H

SPECIFICATIONS

Rated Power:

Bridged 4 ohms:

2000W @ 1kHz @ <0.1% THD

2 x 2 ohms:

1000W per channel @ 1kHz @ <0.1% THD both channels driven

2 x 4 ohms:

700W per channel @ 1kHz @ <0.05% THD both channels driven

2 x 8 Ohms:

425W per channel @ 1kHz @ <0.05% THD both channels driven

1 x 2 Ohms:

1325W per channel @ 1kHz @ <0.1%

THD

1 x 4 Ohms:

825W per channel @ 1kHz @ <0.05%

THD

1 x 8 Ohms:

500W per channel @ 1kHz @ <0.05%

THD

Minimum Load Impedance:

2 Ohms

Maximum RMS Voltage Swing:

71 V

Frequency Response:

10 Hz–100 kHz; +0‚ -0.5 dB @ 1W

Power Bandwidth:

10 Hz–35 kHz; +0‚ -3 dB @ rated

4 Ohm power

THD (2 x 2 ohms):

<0.2% @ 700W per channel from 20 Hz–20 kHz

THD (2 x 4 ohms):

<0.1% @ 600W per channel from 20 Hz–20 kHz

THD (2 x 8 ohms):

<0.1% @ 400W per channel from 20 Hz–20 kHz

Input CMRR:

-85 dB @ 1 kHz

Voltage Gain:

x40 (32 dB)

Crosstalk:

>-70 dB @ 1 kHz @ rated power @ 8 Ohms

Crossover:

Third Order State Variable Filters: 18 dB/octave

Frequency Range: 40 Hz–300 Hz

Hum & Noise:

>-108 dB; “A” weighted reference to rated power @ 8 Ohms

Slew Rate:

> 15V/us

Damping Factor (8 Ohms):

> 500:1 @ 20 Hz–1 kHz

Phase Response:

+5 to -12 degrees from 20 Hz–20 kHz

Input Sensitivity:

1.32V +/- 3% for 1 kHz @ 4 ohm rated power;

1.12V +/- 3% for 1 kHz @

2 Ohm rated power

Input Impedance:

15 k Ohms‚ balanced

Max Input Power w/typical music program:

950W @ 2 Ohms

660W @ 4 Ohms

Max Input Power w/severe music program:

2400W @ 2 Ohms

1650W @ 4 Ohms

Cooling:

Two front panel temperature- dependent variable speed 80mm high- output DC fans

Controls:

2 front panel attenuators‚ rear panel Mode switch‚ Function switch per channel‚ High Pass adjustable filter per channel. High Pass filter bypass switch per channel‚ adjustable subwoofer crossover per channel.

Indicator LEDs:

2 ACL (clip limiting)‚ 2 Signal presence‚ 2 Active status‚ 2 DC protect‚ 2 Temperature limit

Protection:

Thermal‚ DC‚ turn-on bursts‚ subsonic‚ incorrect loads

Connectors:

Combi XLR & 6.3mm phone input; Speakon and Binding Post speaker output; 6.3mm High Pass or Full Range patch connector per channel; 6.3mm Low Pass patch connector per channel; 15 amp IEC mains connector

Construction:

16 ga. steel with cast aluminum front panel and cast handles

Dimensions:

88.9mm x 483mm x 441mm (3.5" x 19" x 17.375" over all. 406 mm (16") inside rack depth

Net Weight:

19.5 kg (43 lbs)

Gross Weight:

20.6 kg (45.5 lbs)

All power measurements made at 120 VAC‚ power transformer cold. 2 ohm power is time limited by magnetic circuit breaker.

42