Peavey XR 696 manual

17 18 19 20 21

16

22

ESET		1			5		5	5			5
		15	3
		13		5
S	PEAK	11	7	0	10	0	10	0	10	0	10
		9
	(-6dB)	PRESET		TIME/SIZE		COLOR/TONE		EFX. TO MON.		EFX. TO MAIN
		DIGITAL EFFECTS						SENDS		POWER		33
		FLS		FEEDBACK LOCATING SYSTEM

63	125	250	500	1K	2K	4K	8K	16K	MONITOR		23
	LEFT/MONITOR EQUALIZATION
									-3	0dB
+12								+12		+3	25
									-6	+6
										+10
-12								-12		GAIN

XR 696

1200W

EQ/PWR AMP

STEREO

MODE

2X600w

POWER MIXER

SELEC

22

125

250

500

1K

2K

4K

8K

STEREO MON/

MAIN

RIGHT/MAIN EQUALIZATION

MAIN

+12

+12

-3

0dB

+3

-6

+6

-12

-12

+10

GAIN

23

DESIGNED IN U.S.A. BUILT UNDER

U.S. PATENT NO. 5,737,428 / 4,318,053

LINE OUTPUT

POWER AMP IN

FT. SW.

48V

EFX. DEFEAT

MONITOR

LEFT/MONO

RIGHT

LEFT

RIGHT

PHANTOM

ON

24

26

27 28 29 30 31 32

25.MONITOR LEVEL: Sets the overall level of the monitor signal that is sent to the Monitor Output Jack. This control also sets the monitor level going to the power amp when in Main/Monitor mode (see System Mode #24).

26.MAIN LEVEL: This is the master level control for the main mix sent to the Left/Mono and Right output jacks. This control sets the Main level going to the power amp when in Main/Monitor mode (see System Mode #24). A good starting position for this control is the center detent position (12:00).

27.PHANTOM POWER SWITCH: Applies 48 V DC voltage to all input XLR connectors to power microphones that require it.

CAUTION! When phantom power is switched on, make sure that any channel you are plugging a mic into is turned down in both the main and monitor mixes. Otherwise, there will be a loud pop in the PA. This is normal. It is best to plug all mics into their respective channels with the phantom power switched off. This reduces noise in the PA and reduces the chances of the mic being damaged. If phantom power is used, do not connect unbalanced microphones or other devices that cannot handle this voltage to the XLR inputs. (Some wireless receivers may be damaged; consult their manuals for compatibility.) The line input 1/4" jacks are not connected to the phantom supply, and are safe for all inputs (balanced or unbalanced). An unbalanced-to-balanced impedance converter, such as the Peavey 5116 or a Peavey 1:1 Interface Adapter, can also be used to isolate a mic from phantom voltage.

7