Great Plains Mfg., Inc.
Installation Instructions 5
3P600 Drive
See Figure 6:
1.Mount bearing and flanges (1) inside end panels of drill frame. Use 5/16 x 1 inch bolts (2), washers and nuts to secure flanges. Leave bolts loose.
2.Install drive shaft (3) through bearings. As you install shaft, place 22 tooth sprocket (4) on shaft to the left of gearbox.
3.Place 17 tooth sprocket (5) on shaft near the left drill frame end panel.
4.Place 12 tooth splined sprocket (6) on left front gearbox shaft. Secure with snap ring (7).
5.Align shaft and tighten flange bolts. Align sprockets (4 and 5). Secure with keys (8 and 9).
3P600 Drive w/Small Seeds Option
If your drill is equipped with a small seeds option, a majority of the agitator drive is already installed.
Refer to Figure 6:
•Place 17 tooth sprocket (5) near left drill frame end panel.
•Align sprocket and secure with key (9).
•Go to step 7b on page 6.
Figure 6
3P600 Drive Assembly
18728
3/31/2004 |