SFODERABILITÁ
17• Per sfoderare il seggiolino, sganciare la sacca dai braccioli sganciando i quattro attacchi e sollevando le alette laterali dai ferretti come in figura.
18• Sganciare i bottoni lateralmente in basso come in figura. Sfilare il cinturino spartigambe agendo da sotto la seduta.
19• Sfilare l'aletta della sacca da sotto lo schienale come in figura. Togliere la sacca dall’alto, facendola passare attraverso il cinturino.
linea accessori
20• Parapioggia Cover All: Parapioggia
21• Borsa Cambio: Borsa con materassino per il cambio del bebè, agganciabile al carrello.
pulizia e manutenzione
•Il vostro prodotto necessita un minimo di manutenzione. Le operazioni di pulizia e manutenzione devono essere effettuate solo da adulti.
•Si raccomanda di tenere pulite tutte le parti in movimento e se occorre, lubrificarle con olio leggero.
•Periodicamente pulire le parti in plastica con un panno umido, non usare solventi o altri prodotti simili.
•Spazzolare le parti in tessuto per allontanare la polvere.
•Proteggere il prodotto da agenti atmosferici, acqua, pioggia o neve; l’esposizione continua e prolungata al sole potrebbe causare cambiamenti di colore in molti materiali.
•Conservare il prodotto in un posto asciutto.
•Per il lavaggio dei rivestimenti, seguire le suguenti indicazioni.
servizio assistenza
Se fortuitamente parti del modello vengono perse o danneggiate, usare solo pezzi di ricambio originali Peg- Pérego. Per eventuali riparazioni, sostituzioni, informazioni sui prodotti, la vendita di ricambi originali e accessori, contatta il Servizio Assistenza
•tel.:
•numero verde: 800.147.414
•fax:
•
•sito internet: www.pegperego.com
cosa pensi di noi?
La
il QUESTIONARIO SODDISFAZIONE CONSUMATORE, segnalando eventuali osservazioni o suggerimenti, che troverà nel nostro sito internet: www.pegperego.com
EN_English
Thank you for choosing a Peg-Pérego product.
•
•This certification offers customers and consumers a guarantee of transparency
and confidence in the company’s mode of operation.
WARNING
•IMPORTANT: read these instructions carefully and keep them for future use. The child’s safety could be at risk if these instructions are not followed.
•This item was designed for the transport of 1 child in the seat.
•Do not use this item for a number of occupants greater than that intended by the manufacturer.
•This item was designed for use in combination with the following Peg Perego Ganciomatic products: the “Caravel 22” chassis - the “Classico” chassis - the “Duette SW” twin chassis - the “Triplette SW” triplet chassis.
•Before use check that the item is correctly attached.
•The assembly and preparation of the item must be carried out by an adult.
•Do not use this item if there are parts missing or signs of breakage.
•Always use the five point harness; always use the harness crotch strap in combination with the waist strap.
•It may be dangerous to leave your child unattended.
•Before use check that all the attachment mechanisms are correctly engaged.
•Do not insert fingers into the mechanisms.
•Be careful not to hurt the child when adjusting the mechanisms (handlebar, backrest).
•Any weights hanging on the handlebar or handles could make the item unstable; follow the manufacturer’s instructions as regards the maximum loads transportable.
•The front bar is not designed to support the child’s weight. It is not designed to keep the child in the seat and does not substitute for the waist belt.
•Do not use the item near to stairs or steps, heat sources, naked flames or dangerous objects within reach of the child.
•The use of accessories not approved by the manufacturer could be dangerous.
instructions for use
CARRIER SEAT
•PrimoGiro Seat Unit: the carrier seat for the PrimoNido bassinet unit. This seat comes with a cover only, since the hood from the PrimoNido bassinet unit can be used with the seat once the baby no longer uses the bassinet unit. The hood can also be ordered separately.
•Duette and Triplette Seat Unit: the carrier seat for the Duette and Triplette twin carriages. This seat comes with a cover and a hood with a zipper that can also be used as a canopy.
SEAT FITTING
1• Fold back the footrest and raise the backrest to the desired position by pulling the handle on the rear of the backrest, as shown in the figure.
2• To fit the front bar, remove the plugs onto the armrests pushing from underneath and detach the squared bushes from the armrests.
3• Place the squared bushes on the front bar as shown in the figure, insert the front bar into the armrests and complete the fitting by replacing the plugs into the armrests.
