Pelco C1607M (6/04)

8C1607M (6/04)

Move the Front Cross-Brace

1. Unscrew and lift out the front cross-brace (found at the center of the unit). Moving this part out of the way will

make it easier for you to access the hard drive mounting baskets.

a. Use a Phillips-head screwdriver to remove the two flat-head screws that secure the front cross-brace. Refer to

Figure 6.

Figure 6. Removing Front Cross-Brace

Contents

Main Page Introduction PARTS LIST TOOLS NEEDED Getting Ready Tools Needed Parts List Page Page Preparing Unit for Drive Installation OPEN THE UNIT CHASSIS Getting Ready C1607M (6/04) 7 COMPONENT LAYOUT Figure 5. DX8000 Interior REAR OF DVR FRONT OF DVR Page Page Disconnect the Data Cable and Power Wire Page Remove the Drive Mount Baskets Install an Additional Drive PREPARE THE DRIVES Page Page SET THE MASTER / SLAVE JUMPERS Figure 15. Setting Drive Jumpers RECONNECT THE DATA AND POWER CABLES gray 1a black blue Page Page Page Page Page Preparing the New Drives to Store Data blue Page Page Page Page PRODUCT WARRANTY AND RETURN INFORMATIONPRODUCT WARRANTY AND RETURN INFORMATION If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico, send goods to: